1. The product must be processed after the replacement of the grinding wheel.

2. The grinding amount and the feeding speed should be reasonably matched to avoid damage to the glass.

3. The glass must be removed from the outside to the inside, and any glass inside cannot be taken.

4. Check the appearance size and quality of the glass after edging, and the unqualified products will not flow into the next process.

5. Special-shaped edging must be processed in strict accordance with the model or geometric figures according to the requirements of customers, so that the grinding surface is smooth and clean.

6. For fine glass with high requirements on appearance quality, the appearance quality inspection should exceed or be equivalent to the quality and appearance requirements of the original glass of automotive grade.

7. When grinding large glass, the layout exceeds 3 square meters, and the lifting hook and suction cup must be used. When multiple people lift the glass on the edger, they cannot run and walk at the same pace.

8. Grinding amount control: Grinding amount below 8mm﹤2.5mm, 10—19mm grinding amount﹤1.5mm; Feeding speed: below 8mm speed﹤2.5m, 10—19mm speed﹤1.5m.

9. Glass stacking after edging: When the specifications (length × width) are different, paper must be added at the junction of the edge and the edge (paper about 100mm × 200mm or string) to prevent the glass from being scratched.
The article is provided by: Glass Machinery Glass Edger 11119d.com.